Wisconsin Parts Database Instructions and Discussion Team/Group > MICHIGAN
> Motors and tools
> Add
> Used
> Without Warranty
> Hp 436A rf power meter 8484A power sensor &cable tested
Hp 436A rf power meter 8484A power sensor &cable tested
HP 436A RF Power Meter Opt 022 with a HP 8484A Power Sensor, a 30dB
Attenuator and HP 11730A Power Sensor Cable.
PLEASE NOTE: The meter, sensor, and attenuator have all been TESTED
by our Lab Technician and they work great!
The HP 436A Power Meter is a general purpose digital power meter intended for manual and automatic RF
and microwave power measurements. It is compatible with the entire series of HP 8480 Power Sensors.
Depending on which power sensor is used, the HP 436A can measure power from -70 dBm (100 pW) to +44 dBm (25 W)
at frequencies up to 50 GHz. The logically organized and uncluttered front panel, and the convenience of push-button
operation and digital display make the HP 436A both easy to interpret and easy to use in any application.
The auto ranging capability allows for "hands-off" operation. The HP 436A measures either absolute or relative power.
It displays absolute power in either watts or dBm, and relative power in dB.
The HP 8484A Power Sensor is a high sensitivity sensor operating from 10 MHz to 18 GHz at power
levels from -70 to -20 dBm. It provides exceptional accuracy and stability even if your test signal is
subjected to multi-tone environments, modulated carriers, or carriers with high harmonics. You also get
extremely low SWR and it's traceable to the U.S. National Institute of standards and Technology (NIST).
An 11708A 30 dB attenuator (Replaced By the Hirose Attenuator) is supplied for calibration with the power
meter 0 dBm, 50 MHz reference.
The 30 dB Attenuator is supplied in lieu of the HP 11708A for calibration with
the power meter 0 dBm, 50 MHz reference. The Attenuator is not a replacement for the HP 11708A
Attenuator, but can be used up to 2.0 GHz, for the initial check, and meter calibration of the sensor
* Measurement range: 100 pW to 10 uW (-70 dBm to -20 dBm)
* 50 ohm impedance N (m) connector
* Option 22: HPIB (IEEE) interface
WARNING: Hooking sensor to power reference output WITHOUT the 30 dB Attenuator
will cause permanent damage to sensor.
SOLD WITH A 7-DAY RIGHT OF RETURN!
