Wisconsin Parts Database Instructions and Discussion Team/Group > INDIANA
> Machine Parts
> Remove
> 1000MW 650NM red laser +analog+tec+fan+power supply
1000MW 650NM red laser +analog+tec+fan+power supply
Please read this user manual before operate this laser modules safety and properly, and pay attention to that it will not be warranty by operating mistake!
Product's Technical Parameter
Near TEM00(means the beam is not fully dot)
Beam Height At Aperature(1/e2 Representative Value)
Beam Height From Base Plate:
Pointing Stability After Warm-up:
Optional,1-10KHZ or higher. If request,Higher rate up to 40KHZ available
Optional,1-10KHZ or higher..0 min when 0-5VDC signal input
1) Please connect the laser modules with the power supply by the cable. the serial number of them should be matched or it will damage the laser modules. please do not press the cable roughly which connetes the machine and power supply in case blocking the lines inside the laser machine
2) Please fix the laser machine onto a flat metal board to drop heat well, or you can put a cooler beside it.
3) Please do not use laser modules at the room full of dust and be careful of keeping machine clean. please stick labels on the light holes to protect the machine if the laser moduls are not used for a long time.
1) Do not crash or shock the machine roughly.
2) Do not direct exposure the skin of hurman or animal, especially the eyes, under the laser light, or it may be harmful.
3) Do not open the machine and power supply. it would not be warranted by us.
