Wisconsin Parts Database Instructions and Discussion Team/Group > WISCONSIN
> Electrical Components
> Add
> New
> With Warranty
> Avalan AW900XTR 900MHZ wireless ip ethernet bridge kit
Avalan AW900XTR 900MHZ wireless ip ethernet bridge kit
AW900xTR Radios are now IP addressable, with remote configuration & diagnostic tools, and support multiple IP addresses at each remote node!
The AW900xTR product line allows you to build a long-range, non-line-of-sight, point-to-multipoint wireless Ethernet solution that can enable fringe IP devices, including IP access control readers, SCADA clients, bio-scanners, printers, PCs, VoIP phones, point-of-sale devices, digital signage, or Internet kiosks.
The AW900xTR solutions offer the ideal combination of price, range, data rate, security, interference avoidance, quality-of-service, and ease-of-use.
* 1 x AW900xTR outdoor radio
* 1 x AW2 2.5 dBi omni-directional antenna
* 1 x 110 VAC to 12 VDC power adapter
* 1 x Power over Ethernet (PoE) injector
Includes AW2 2.5 dBi omni-directional antenna.
Recommended upgrades: AW5H-900, AW5P-900, AW10, AW11 (shown), and AW15 all FCC approved
* NEW! Built-in spectrum analyzer
* NEW! 128 bit AES encryption, FIPS 197 - NIST Certified
* NEW! Remote diagnostics and link analysis with browser interface
* NEW! Radios are IP addressable*, with Remote Configuration & Diagnostic Tools
* NEW! Radios Support Multiple IP Addresses at Each Remote Node**
* Radio can be configured as an access point or client
* Simple plug and play minimal user
* Install up to 16 clients per access point
* Can operate up to 12 access points, each on its own non-overlapping channel
* Does not require an FCC license to operate or install
* High RF output power provides maximum foliage and / or wall penetration
* There is a limit of 50 routable MAC addresses per access point. This allows an Ethernet switch to be attached to subscriber units ( Client in image at left), but limits to 50 the total number of Ethernet devices to which the access point can connect.
** There is a limit of 16 active subcsriber units for each access point. A total of 12 access points (in the 900 MHz band) can be deployed to support up to 192 subscriber units across a given site.
* AW10, AW11, AW15 directional
* AW2, AW5H-900, or AW5P-900 omni-directional
* RF transmission rate : 1.536 Mb/s
* Ethernet throughput : 935 Kb/s
* Output power : +21 dBm (4 Watts EIRP used with 15 dBi antennae)
* Receive sensitivity : -97 dBm at 10e-4 BER (-112 dBm with 15 dBi antennae)
* Radio link budget : 148 dB with 15 dBi antennae
Range : 40 miles LOS with 15 dBi antennae
* Radio channels/bandwidth : 12 non-overlapping with 2.0833 MHz spacing and 1.75 MHz occupied bandwidth
Manual frequency select : Channel selected with DIP switch or via Web browser interface
* Connector types : RF RPTNC Female / 10-100 baseT Ethernet RJ45 / Power Jack P5-2.1 mm ID
* Status LEDs : Power, Ethernet Link, RF RX, RF TX, 4/Channel, and 6/Link Quality
* Error correction technique : Sub-block error detection and retransmission
* Adjacent-band rejection : SAW receiver filter attenuates cellular and pager interference
* Regulator type : Switching regulator
* Browser Management Tools : QoS Statistics, Network Settings, Spectrum Analyzer and Firmware Upgrading
* Power consumption : Transmit: 1.7 Watts Receive: 0.8 Watts
* Voltage : Power over Ethernet 9-48 VDC over Ethernet - 4/5 positive and 7/8 ground
* Temperature range : -40o C to 70o C
* Size : 170 x 80 x 50 mm; 0.570 Kg
