Wisconsin Parts Database Instructions and Discussion Team/Group > OTHER STATES
> Motors and tools
> Add
> Used
> Tool maker lathe or grinder parts, fixtures, accessorie
Tool maker lathe or grinder parts, fixtures, accessorie
Tool Maker Lathe or Grinder Parts, Fixtures, Accessories
These came from a lot of accessories that were supposed to be from a Leblond lathe, but many were from grinders. The following descriptions and approximate measurements are all to the best of my ability given my crude measuring instruments.
The fixture with 4 screws protruding from the top is 15.8cm in length (excluding the 4 screws) and the face is 4.2cm in diameter with a dimple in the middle. The shaft appears to be tapered with a 1.5cm diameter threaded hole in the end.
The other is 2.7cm in diameter at the top with a dimple in the middle of the face. The next section is 3.4cm in diameter with a small portion ground flat and a threaded hole is in the middle of the flat portion. The main shaft is 2.5cm in diameter, 10.5cm long and threaded on the end. The overall length is 20.5cm. Various collars fit on the shaft, each with a 7mm keyway and are 1.9cm long, 3.8cm (2 of these) and 7.6cm long. The one with the lip has a 4mm keyway.
The last piece is 8.5cm long. The knurled end is 1.9cm in diameter with a dimple in the end. The smaller end has a 1.2cm diameter shaft.
